Yamaha RXV1800 Owner's Manual - Page 45
If an error screen appears, If WARNING appears, then press - troubleshooting
UPC - 027108928463
View all Yamaha RXV1800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
PREPARATION ■ If an error screen appears Press 3l / h to select "RETRY" or "EXIT" and then press 3ENTER. The following display is an example where "E-9:USER CANCEL" appears in the OSD. ERROR E-9:USER CANCEL Don't operate any function . >RETRY EXIT [p]/[[]: Select [ENTER]: Enter Choices: RETRY, EXIT • Select "RETRY" to retry the "AUTO SETUP" procedure. • Select "EXIT" to exit from the "AUTO SETUP" procedure. y • If "E-5:NOISY" appears in the OSD, you can also select "PROCEED" and let this unit continue the automatic setup. However, we recommend that you perform the automatic setup procedure again for more accurate adjustment. ERROR E-5:NOISY Keep silent . >RETRY EXIT PROCEED [p]/[[]: Select [ENTER]: Enter • If "E-10:INTERNAL ERROR" appears in the OSD, you can select only "EXIT". • For details about each error message, refer to the "AUTO SETUP" section in "Troubleshooting" on page 128. ■ If "WARNING" appears When this unit detects potential problems during the automatic setup procedure, "WARNING" appears in the result display. Check the warning messages to correct your speaker settings. Note Warnings differ from errors in that warnings do not cancel the "AUTO SETUP" procedure. Optimizing the speaker setting for your listening room 1 Make sure the pointer is pointing at "WARNING" and then press 3ENTER to display the detailed information about the warning. The number on the right of "WARNING" indicates the number of warning messages. AUTO SETUP WARNING 2 . RESULT SP : 5/4/0.1 DIST: 14.0/17.0ft LVL : -10.0/+5.0dB >SET CANCEL [ p [ ]/[ ]: UP/DOWN [ENTER]: Detail 2 Press 3l / h repeatedly to toggle between the warning displays. WARNING W-1:OUT OF PHASE Reverse channel FL --- CENTER --- PR SL --- SBL --- [p]/[[]: Select [ENTER]: Return y • For details about each warning message, refer to the "AUTO SETUP" section in "Troubleshooting" on page 128. • When the corresponding warning message is not applicable to a speaker, "- - -" is displayed instead. • If the volume level setting of the connected subwoofer is too high or low, "TOO LOUD" (the volume level setting is too high) or "TOO LOW" (the volume level setting is too low) is displayed in the "W-3:LEVEL ERROR" display. Adjust the volume level setting of the connected subwoofer appropriately. WARNING W-3:LEVEL ERROR --- FR CENTER PL --- --- SR --- SBL SWFR:TOO LOUD [p]/[[]: Select [ENTER]: Return 3 Press 3ENTER to return to the top result display. y The adjustment are made even if "WARNING" appears, however the adjustment may not be optimal. English 41 En