ZyXEL ARMOR Z1 - Model NBG6816 User Guide - Page 95
Table 33, LABEL, DESCRIPTION, No Security, WPA2-PSK, Apply, Cancel
View all ZyXEL ARMOR Z1 - Model NBG6816 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
Chapter 11 Wireless LAN Figure 59 Expert > Wireless > Guest Wireless > Guest Wireless Setup: Edit The following table describes the labels in this screen. Table 33 Expert > Wireless > Guest Wireless > Guest Wireless Setup: Edit LABEL Active Name (SSID) Hide SSID Intra-BSS Traffic Blocking DESCRIPTION Select this to activate the SSID profile. The SSID (Service Set IDentity) identifies the Service Set with which a wireless client is associated. Enter a descriptive name (up to 32 printable characters found on a typical English language keyboard) for the wireless LAN. Select this check box to hide the SSID in the outgoing beacon frame so a station cannot obtain the SSID through scanning using a site survey tool. A Basic Service Set (BSS) exists when all communications between wireless clients or between a wireless client and a wired network client go through one access point (AP). WMM QoS Intra-BSS traffic is traffic between wireless clients in the BSS. When Intra-BSS is enabled, wireless clients can access the wired network and communicate with each other. When Intra-BSS is disabled, wireless clients can still access the wired network but cannot communicate with each other. Check this to have the ARMOR Z1 automatically give a service a priority level according to the ToS value in the IP header of packets it sends. Enable Bandwidth Management for Guest WLAN Maximum Bandwidth Security Mode WMM QoS (Wifi MultiMedia Quality of Service) gives high priority to voice and video, which makes them run more smoothly. Select this to turn on bandwidth management for the Guest Wi-Fi network. Enter a number to specify maximum bandwidth the Guest Wi-Fi network can use. Select WPA-PSK or WPA2-PSK to add security on this wireless network. The wireless clients which want to associate to this network must have same wireless security settings as this device. After you select to use a security, additional options appears in this screen. See Section 11.3 on page 90 for detailed information on different security modes. Or you can select No Security to allow any client to associate this network without authentication. Apply Cancel Note: If the WPS function is enabled (default), only No Security and WPA2-PSK are available in this field. Click Apply to save your changes back to the ARMOR Z1. Click Cancel to reload the previous configuration for this screen. ARMOR Z1 User's Guide 95