ZyXEL P-314Plus User Guide - Page 146

Prestige 314 PLUS Broadband Sharing Gateway with 4-Port Switch Menu 11.6 - Traffic Redirect Setup Active= Yes Configuration: Backup Gateway IP Address= 0.0.0.0 Metric= 15 Check WAN IP Address= 0.0.0.0 Fail Tolerance= 2 Period (sec)= 5 Timeout (sec)= 3 Press ENTER to Confirm or ESC to Cancel: Press Space Bar to Toggle. Figure 10-4 Menu 11.6 - Traffic Redirect Setup Table 10-2 Traffic Redirect Setup FIELD DESCRIPTION EXAMPLE Active Press [SPACE BAR] and select Yes (to enable) or No (to disable) traffic Yes redirect setup. The default is No. When the Active field is Yes, you must configure every field in this screen unless you are using PPPoE or PPTP encapsulation (except Check WAN IP Address and Timeout). If you don't configure these fields and are using PPTP or PPPoE encapsulation, then the Prestige checks the PPPoE channel or PPTP tunnel to determine if the WAN connection is down. Configuration: Backup Gateway IP Address Enter the IP address of your backup gateway in dotted decimal notation. The Prestige automatically forwards traffic to this IP address if the Prestige's Internet connection terminates. 0.0.0.0 Metric Enter a number from 1 to 15 to set this route's priority among the Prestige's routes (see Metric on page 10-1) The smaller the number, the higher priority the route has. 15 (default) Check WAN Enter the IP address of a reliable nearby computer (for example, your IP Address ISP's DNS server address) to test your Prestige's WAN accessibility. 0.0.0.0 The Prestige uses the default gateway IP address if you do not enter an IP address here. If you are using PPTP or PPPoE Encapsulation, enter "0.0.0.0" to configure the Prestige to check the PVC (Permanent Virtual Circuit) or 10-4 Traffic Redirect