ZyXEL P-314Plus User Guide - Page 168

Prestige 314 PLUS Broadband Sharing Gateway with 4-Port Switch TFTP [-i] host get rom-0 config.rom where "i" specifies binary image transfer mode (use this mode when transferring binary files), "host" is the Prestige IP address, "get" transfers the file source on the Prestige (rom-0 name of the configuration file on the Prestige) to the file destination on the computer and renames it config.rom. TFTP GUI Clients The following table describes some of the fields that you may see in some TFTP GUI clients. Table 12-3 General Commands for TFTP GUI Clients COMMAND Host Send/Fetch Local File Remote File Binary Abort DESCRIPTION Enter the IP address of the Prestige. 192.168.1.1 is the Prestige's default IP address when shipped. Use "Send" to upload the file to the Prestige and "Fetch" to back up the file on your computer. Enter the path and name of the firmware file (*.bin extension) or configuration file (*.rom extension) on your computer. This is the filename on the Prestige. The filename for the firmware is "ras" and for the configuration file, is "rom-0". Transfer the file in binary mode. Stop transfer of the file. Refer to the TFTP and FTP over WAN Will Not Work When section to read about configurations that disallow TFTP and FTP to work over WAN. 12.2.4 Backup Via Console Port Backup configuration via console port by following the HyperTerminal procedure shown next. Procedures using other serial communications programs should be similar. Step 1. Display menu 24.5 and enter "y" at the following screen. 12-6 Firmware and Configuration Maintenance