ZyXEL P-662HW-61 User Guide - Page 438

Appendix J Command Interpreter Command Examples This section provides some examples of commands you can use on the ZyXEL Device. This list is intended as a general reference of examples. The commands available in your ZyXEL Device may differ from the examples given here. See the other appendices for more examples. Configuring What You Want the ZyXEL Device to Log 1 Use the sys logs load command to load the log setting buffer that allows you to configure which logs the ZyXEL Device is to record. 2 Use sys logs category to view a list of the log categories. Figure 297 Displaying Log Categories Example ras> sys logs category 8021x access error icmp javablocked mten cdr pki tcpreset traffic urlforward wireless attack ike packetfilter tls upnp display ipsec ppp remote urlblocked 3 Use sys logs category followed by a log category to display the parameters that are available for the category. Figure 298 Displaying Log Parameters Example ras> sys logs category access Usage: [0:none/1:log/2:alert/3:both] [0:don't show debug type/1:show debug type] 4 Use sys logs category followed by a log category and a parameter to decide what to record. Use 0 to not record logs for that category, 1 to record only logs for that category, 2 to record only alerts for that category, and 3 to record both logs and alerts for that category. Not every parameter is available with every category. 5 Use the sys logs save command to store the settings in the ZyXEL Device (you must do this in order to record logs). Displaying Logs • Use the sys logs display command to show all of the logs in the ZyXEL Device's log. • Use the sys logs category display command to show the log settings for all of the log categories. 438 P-662H/HW-D Series User's Guide