ZyXEL P-662HW-61 User Guide - Page 466
Appendix L Log Descriptions, P-662H/HW-D Series User's Guide, IKE Logs continued
View all ZyXEL P-662HW-61 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 466 highlights
Appendix L Log Descriptions Table 195 IKE Logs (continued) LOG MESSAGE DESCRIPTION Remote IP / conflicts The security gateway is set to "0.0.0.0" and the router used the peer's "Local Address" as the router's "Remote Address". This information conflicted with static rule #d; thus the connection is not allowed. Phase 1 ID type mismatch This router's "Peer ID Type" is different from the peer IPSec router's "Local ID Type". Phase 1 ID content mismatch This router's "Peer ID Content" is different from the peer IPSec router's "Local ID Content". No known phase 1 ID type found The router could not find a known phase 1 ID in the connection attempt. ID type mismatch. Local / Peer: The phase 1 ID types do not match. ID content mismatch The phase 1 ID contents do not match. Configured Peer ID Content: The phase 1 ID contents do not match and the configured "Peer ID Content" is displayed. Incoming ID Content: The phase 1 ID contents do not match and the incoming packet's ID content is displayed. Unsupported local ID Type: The phase 1 ID type is not supported by the router. Build Phase 1 ID The router has started to build the phase 1 ID. Adjust TCP MSS to%d The router automatically changed the TCP Maximum Segment Size value after establishing a tunnel. Rule input idle time out, disconnect The tunnel for the listed rule was dropped because there was no inbound traffic within the idle timeout period. XAUTH succeed! Username: The router used extended authentication to authenticate the listed username. XAUTH fail! Username: The router was not able to use extended authentication to authenticate the listed username. Rule[%d] Phase 1 negotiation The listed rule's IKE phase 1 negotiation mode did not match mode mismatch between the router and the peer. Rule [%d] Phase 1 encryption The listed rule's IKE phase 1 encryption algorithm did not algorithm mismatch match between the router and the peer. Rule [%d] Phase 1 authentication algorithm mismatch The listed rule's IKE phase 1 authentication algorithm did not match between the router and the peer. Rule [%d] Phase 1 authentication method mismatch The listed rule's IKE phase 1 authentication method did not match between the router and the peer. Rule [%d] Phase 1 key group The listed rule's IKE phase 1 key group did not match mismatch between the router and the peer. Rule [%d] Phase 2 protocol mismatch The listed rule's IKE phase 2 protocol did not match between the router and the peer. Rule [%d] Phase 2 encryption The listed rule's IKE phase 2 encryption algorithm did not algorithm mismatch match between the router and the peer. 466 P-662H/HW-D Series User's Guide