ZyXEL P-662HW-61 User Guide - Page 439
Routing Command
View all ZyXEL P-662HW-61 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 439 highlights
Appendix J Command Interpreter • Use the sys logs display [log category] command to show the logs in an individual ZyXEL Device log category. • Use the sys logs clear command to erase all of the ZyXEL Device's logs. Log Command Example This example shows how to set the ZyXEL Device to record the access logs and alerts and then view the results. ras> sys logs load ras> sys logs category access 3 ras> sys logs save ras> sys logs display access # .time source destination message 0|06/08/2004 05:58:21 |172.21.4.154 |224.0.1.24 BLOCK Firewall default policy: IGMP (W to W/ZW) 1|06/08/2004 05:58:20 |172.21.3.56 |239.255.255.250 BLOCK Firewall default policy: IGMP (W to W/ZW) 2|06/08/2004 05:58:20 |172.21.0.2 |239.255.255.254 BLOCK Firewall default policy: IGMP (W to W/ZW) 3|06/08/2004 05:58:20 |172.21.3.191 |224.0.1.22 BLOCK Firewall default policy: IGMP (W to W/ZW) 4|06/08/2004 05:58:20 |172.21.0.254 |224.0.0.1 BLOCK Firewall default policy: IGMP (W to W/ZW) 5|06/08/2004 05:58:20 |172.21.4.187:137 |172.21.255.255:137 BLOCK Firewall default policy: UDP (W to W/ZW) notes |ACCESS |ACCESS |ACCESS |ACCESS |ACCESS |ACCESS Routing Command Syntax: ip nat routing [0:LAN] [0:no|1:yes] Use this command to set the ZyXEL Device to route traffic that does not match a NAT rule through a specific interface. An example of when you may want to use this is if you have servers with public IP addresses connected to the LAN. The following command example sets the ZyXEL Device to route traffic that does not match a NAT rule through the LAN interface. P-662H/HW-D Series User's Guide 439