ZyXEL WAP3205 v2 User Guide - Page 122
Internet Access
View all ZyXEL WAP3205 v2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 122 highlights
Chapter 13 Troubleshooting 13.3 Internet Access I cannot access the Internet. 1 Check the hardware connections, and make sure the LEDs are behaving as expected. See the Quick Start Guide. 2 Make sure the WAP3205 is connected to a broadband modem or router with Internet access. 3 If you are trying to access the Internet wirelessly, make sure the wireless settings in the wireless client are the same as the settings in the AP. • Go to Network > Wireless LAN > General > WDS and check if the WAP3205 is set to bridge mode. Select Disable and try to connect to the Internet again. 4 Disconnect all the cables from your device, and follow the directions in the Quick Start Guide again. 5 Go to Maintenance > Sys OP Mode. Check your System Operation Mode setting. • Select Access Point Mode if your WAP3205 bridges traffic between clients on the same network. • Select Client Mode if your WAP3205 needs a wireless client to connect to an existing access point. • Select Universal Repeater Mode if you want to have wireless clients associate with the WAP3205 and also want to connect the WAP3205 to an existing access point. 6 If the problem continues, contact your ISP. I cannot access the Internet anymore. I had access to the Internet (with the WAP3205), but my Internet connection is not available anymore. 1 Check the hardware connections, and make sure the LEDs are behaving as expected. See the Quick Start Guide and Section 1.5 on page 20. 2 Reboot the WAP3205. 3 If the problem continues, contact your ISP. 122 WAP3205 User's Guide