Canon VIXIA HF R400 Instruction Manual - Page 171
Canon Service Center.
View all Canon VIXIA HF R400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 171 highlights
Memory card cover is open - The memory card cover was opened while the memory card was being accessed. Stop the Wi-Fi function in use and end the Wi-Fi connection. Multiple access points detected. Try the operation again. - There are multiple access points sending out a WPS signal at the same time. Try the operation again later or perform setup using the [WPS: PIN Code] or [Search for Access Points] option (A 137). No access points found - The access point set in the camcorder could not be found. - Cordless phones, microwave ovens, refrigerators and other appliances may interfere with the wireless signal. Try using the camcorder in a location farther away from such appliances. - Make sure that you use the access point's SSID for the camcorder's Wi-Fi settings (A 139). - If the access point is using MAC address filtering, enter the camcorder's MAC address in the access point's configuration screen. Unable to access configuration files - Turn off the camcorder. After a short while, turn it on again. If the problem persists contact a Canon Service Center. Unable to complete WPS. Try the operation again. - Some wireless routers require pressing and holding the Wi-Fi Protected Setup (WPS) button. For details, refer to the instruction manual of your wireless router. - Make sure to touch [OK] on the camcorder's screen within 2 minutes of activating the Wi-Fi Protected Setup signal on the wireless router, whether by pressing the button or by entering the PIN code. Unable to complete WPS. - Turn off the camcorder and wireless router. After a short while, turn them on again and try again. If the problem persists, perform setup using the [Search for Access Points] option (A 137). Unable to connect - Cordless phones, microwave ovens, refrigerators and other appliances may interfere with the wireless signal. Try using the camcorder in a location farther away from such appliances. Unable to obtain an IP address - If you are not using a DHCP server, connect using the [Manual Setup] option and enter the IP address using the [Manual] option (A 140). - Turn on the DHCP server. If it is already on, make sure it is functioning properly. - Make sure the address range for the DHCP server is sufficient. - Turn on the DNS server. If it is already on, make sure it is functioning properly. - Make sure that the DNS server's IP address and the name for that address are correctly configured. - Set the DNS server's IP address in the camcorder. - If you are not using a DNS server, set the DNS address to [0.0.0.0]. - If you are using a wireless gateway router, make sure all of the devices in the network, including the camcorder, are configured with the correct gateway address. Additional Information 171