Cisco AIR-AP1242AG-E-K9 Hardware Installation Guide - Page 88
Removing the 5-GHz Radio Module, Step 4
View all Cisco AIR-AP1242AG-E-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Removing a 5-GHz Radio Module Chapter 8 5-GHz Radio Module Upgrade Step 4 Insert your fingers into the base (latch opening) of the 5-GHz radio module (closest to the access point) and pull straight out from the access point (see Figure 8-3). Figure 8-3 Removing the 5-GHz Radio Module 74629 Step 5 Step 6 For a radio module with built-in antenna, fold the antenna down (towards the attached radio card) and insert the module into a static protected bag. For a radio module with connectors, insert the radio module into a static protected bag. To install a new 5-GHz radio module, see the "Installing a 5-GHz Radio Module" section on page 8-5. Cisco Aironet 1200 Series Access Point Hardware Installation Guide 8-4 OL-4310-05
8-4
Cisco Aironet 1200 Series Access Point Hardware Installation Guide
OL-4310-05
Chapter 8
5-GHz Radio Module Upgrade
Removing a 5-GHz Radio Module
Step 4
Insert your fingers into the base (latch opening) of the 5-GHz radio module (closest to the access point)
and pull straight out from the access point (see
Figure 8-3
).
Figure 8-3
Removing the 5-GHz Radio Module
Step 5
For a radio module with built-in antenna, fold the antenna down (towards the attached radio card) and
insert the module into a static protected bag.
Step 6
For a radio module with connectors, insert the radio module into a static protected bag.
To install a new 5-GHz radio module, see the
“Installing a 5-GHz Radio Module” section on page 8-5
.
74629