HP StorageWorks 2/32 SAN switch 2/32 version 4.0.x installation guide - Page 45
Connecting AC Power, Attach the remaining ends of the power cords to power outlets.
View all HP StorageWorks 2/32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Installing the SAN Switch 2/32 Connecting AC Power Use these steps to power on the SAN Switch 2/32. Caution: Do not plug the power cords into the power source until the switch is completely installed in the rack. 1. Connect the SAN Switch 2/32 power cords to the power connectors on the switch, see Figure 12. Figure 12: Connecting the power cords SHR-2571A 2. Attach the remaining ends of the power cords to power outlets. 3. Turn on the power switch (the 1 position indicates power on, the O position indicates power off). The switch automatically runs POST. WARNING: Do not connect the switch to the network until the IP address is correctly set. For instructions on setting the IP address, see "Configuring SAN Switch 2/32 Network Addressing," later in this chapter. SAN Switch 2/32 Installation Guide 45