HP StorageWorks 4/16 HP StorageWorks DC and DC04 SAN Backbone Director Switche - Page 126

Installation task Time estim- Items required ate Installing power cables and powering on the DC04 SAN Director 20 minutes Power cables and serial cable (provided in the DC04 SAN Director accessory kit) Installing SFPs 30 minutes SFP optical transceivers Attaching fiber optic cables, cable 60 minutes Fiber optic cables and cable ties ties, and cable guides Establishing serial connection, logging on to DC04 SAN Director, and configuring IP addresses 20 minutes Serial cable (provided in the DC04 SAN Director accessory kit) Workstation computer with a serial port or terminal server port and a terminal emulator application (such as HyperTerminal) Ethernet IP addresses for the DC04 SAN Director Installing Ethernet cable(s) and configuring the DC04 SAN Director name, policies, domain ID, PIDs, date and time and additional system parameters 20 minutes Ethernet cabling (optional) for Telnet access. All other configuration parameters optional. Refer to the HP StorageWorks Fabric OS 6.2.x administrator guide for Port Identifier (PID) information. Site preparation, unpacking the DC04 SAN Director IMPORTANT: See "Regulatory compliance and safety notices" on page 229 for important safety guidelines before setting up your DC04 SAN Director. The following steps are required to ensure correct installation and operation: 1. Provide a space that is 9 rack units (9U) high, 61.19 cm (24.09 in.) deep, and 43.74 cm (17.22 in.) wide. 1U is equal to 4.45 cm (1.75 in.) 2. The DC04 SAN Director can be installed facing in either direction, provided that serviceability and cooling requirements are met. 3. Plan for cable management before installing the chassis. Cables can be managed in a variety of ways, such as by routing cables below the chassis, to either side of the chassis, through cable channels on the sides of the cabinet, or by using patch panels (see "Managing cables" on page 139). 126 DC04 SAN Director Installation