HP StorageWorks 4/16 HP StorageWorks DC and DC04 SAN Backbone Director Switche - Page 170
Installing the chassis door, Replacing the vertical cable management assembly
View all HP StorageWorks 4/16 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 170 highlights
Installing the chassis door To install the chassis door (see Figure 63 on page 170): 1. Align the holes in the door with the pins in the chassis 2. Push the door into place. Figure 63 Removing or replacing a chassis door Replacing the vertical cable management assembly The DC04 SAN Director is equipped with two vertical cable management finger assemblies. It can continue to operate during the replacement of the cable management fingers. Due to the horizontal orientation of the blades in the DC04 SAN Director, the finger assemblies are attached to the uprights of the mounting rack. The replacement procedure for the vertical cable management fingers takes less than five minutes. You will need a #1 Phillips screwdriver. Removing a cable management finger assembly CAUTION: Wear a grounded ESD strap when handling DC04 SAN Director components. The DC04 SAN Director chassis provides a grounding connection above the power connectors. Also, store ESD-sensitive components in antistatic packaging. To remove the cable management comb: 1. Rearrange the cables around one of the cable management finger assemblies. 170 Replacing DC04 SAN Director field-replaceable units (FRUs)