HP Surestore 64 FW 05.01.00 and SW 07.01.00 Director 2/64 Installation Guide ( - Page 108
Modify Alerts, Activate or Deactivate Alerts, Hardware View, Con gt; Threshold Alerts
View all HP Surestore 64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
Installing and Configuring the Director 2/64 Modify Alerts Use the following steps to modify an existing threshold alert configuration. 1. At the Hardware View page, choose Configure > Threshold Alerts. The Configure Threshold Alerts dialog box displays. Choose the alert that you want to modify by clicking the alert information in the table. If the alert is active, an error message displays prompting you to deactivate the alert. 2. If the alert is active, click Deactivate, then choose the alert information in the table again. 3. Click Modify. An initial Modify Threshold screen displays where you can change the threshold type. 4. Choose a threshold type from the drop-down list. 5. Click Next when you are done. A Modify Threshold screen displays where you can change the % utilization, cumulative minutes for the threshold to occur before notification, and the time interval for measuring throughput and for alert notification. 6. Make appropriate changes, then continue through the Modify Threshold screens, making changes as necessary, until the summary screen displays the alert configuration. 7. Perform either of the following steps: ■ If you need to change any parameters, click Previous or Next to display the desired Modify Threshold screen. ■ Click Finish when you are done. Activate or Deactivate Alerts Use the following steps to activate or deactivate existing threshold alerts. In the active state, notifications are generated for the alert. In the inactive state, notifications do not occur. 1. At the Hardware View page, choose Configure > Threshold Alerts. The Configure Threshold Alerts dialog box displays. The port's current state, inactive or active, is listed under the State column. 2. To change the state, choose the alert using the alert information in the table. 3. If the alert is active, choose Deactivate to change to the inactive state. If the alert is inactive, choose Activate to change to the active state. 108 Director 2/64 Installation Guide