HP Surestore 64 FW 05.01.00 and SW 07.01.00 Director 2/64 Installation Guide ( - Page 78
HyperTerminal dialog box, Request completed OK
View all HP Surestore 64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
Installing and Configuring the Director 2/64 Figure 34: HyperTerminal dialog box 11. To change director network addresses, type the following at the C> prompt and press Enter. ipconfig xxx.xxx.xxx.xxx.yyy.yyy.yyy.yyy.zzz.zzz.zzz.zzz The IP address format is xxx.xxx.xxx.xxx. The subnet mask format is yyy.yyy.yyy.yyy. The gateway address format is zzz.zzz.zzz.zzz. The octets xxx, yyy, and zzz are decimals from 0 through 255. If a network address is to remain unchanged, type the current address in the respective field. When the new network addresses are configured at the director, the message Request completed OK displays at the bottom of the HyperTerminal window. 12. Choose Exit from the File drop-down menu. 13. Click Yes. 14. Click No to exit and close the HyperTerminal application. 15. Power off the maintenance terminal: a. Choose Start > Shut Down. The Shut Down Windows dialog box displays. b. Choose Shut down and click Ok to power off the PC. 16. Disconnect the RS-232 null modem cable from the director and the maintenance terminal. Replace the protective cap over the maintenance port. 78 Director 2/64 Installation Guide