HP Surestore 64 FW 05.01.00 and SW 07.01.00 Director 2/64 Installation Guide ( - Page 109
Delete Alerts, Test Remote Notification, Test Remote Notification dialog box
View all HP Surestore 64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
Installing and Configuring the Director 2/64 Delete Alerts Use the following steps to delete existing threshold alerts. 1. At the Hardware View page, choose Configure > Threshold Alerts. The Configure Threshold Alerts dialog box displays. 2. Choose the alert that you want to delete by selecting the alert information in the table and click Delete. A message displays asking you to confirm the deletion. 3. Click Yes. The alert is removed from the dialog box. Test Remote Notification If the e-mail and one of the call-home notification features are enabled, set up the HAFM application to test these remote notification features. Because the features are configured at the HAFM application, call-home and e-mail notification are enabled for multiple directors. Note: Prior to using test remote notification, complete the steps in the previous sections, "Configure and Enable E-mail Notification" and "Configure and Enable Call-Home Features." Use these steps to test remote notification: 1. Close the Hardware View page for the director by clicking Close at the Navigation Control panel. 2. Choose Maintenance > Test Remote Notification. The Test Remote Notification dialog box displays, as shown in Figure 53. Figure 53: Test Remote Notification dialog box 3. Check the Call-Home and E-Mail check boxes. 4. Click Send Test. Call-home and e-mail test messages are transmitted and an Information dialog box displays. Director 2/64 Installation Guide 109