HP Surestore 64 FW 05.01.00 and SW 07.01.00 Director 2/64 Installation Guide ( - Page 90
Con Switch Parameters dialog box, Switch Parameters
View all HP Surestore 64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
Installing and Configuring the Director 2/64 Caution: Setting the director offline terminates all Fibre Channel connections. 2. Choose Configure > Operating Parameters > Switch Parameters. The Configure Switch Parameters dialog box displays, as shown in Figure 41. Figure 41: Configure Switch Parameters dialog box Ordinarily, you do not need to change values in this dialog box from their defaults. The only exception is the Preferred Domain ID. Change this value if the director will participate in a multi-switch fabric. 1. Use information under "Switch Parameters" to change settings as required for parameters in this dialog box. 2. After you change settings, click the Activate button. 3. Set the director online. For instructions, see "Set the Director Online" on page 87. Switch Parameters Configure the following parameters as required by your fabric. Domain ID The domain identification is a value between 1 and 31 that provides a unique identification for the director in a fabric. A fabric director cannot contain the same domain ID as another director or their E_Ports will segment when they try to join. In the Configure Switch Parameters dialog box, a field is provided to enter a preferred domain ID and a check box is provided to enable this ID as an insistent domain ID. 90 Director 2/64 Installation Guide