HP Surestore 64 FW 05.01.00 and SW 07.01.00 Director 2/64 Installation Guide ( - Page 111
Enable Embedded Web Server, Enable Telnet, Connect Cables to the Fibre Channel Ports
View all HP Surestore 64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
Installing and Configuring the Director 2/64 Enable Embedded Web Server Use the following steps to enable EWS: 1. At the Hardware View page, choose Configure > Enable Web Server. Choosing Enable Web Server automatically places a check mark in the check box. 2. Choose Enable Web Server again to remove the check mark and disable the EWS interface. When disabled, remote users cannot access the interface. For complete procedures on using EWS, refer to the HP StorageWorks Embedded Web Server User Guide. Enable Telnet Use the following steps to enable Telnet: 1. At the Hardware View, choose Configure > Enable Telnet. Choosing Enable Telnet automatically places a check mark in the check box. 2. Choose Enable Telnet again to remove the check mark and disable telnet access. When disabled, remote users cannot access the director through telnet. Connect Cables to the Fibre Channel Ports Use these steps to connect Fibre Channel port cables: 1. Route the fiber-optic cables from customer-specified devices to ports at the front of the Director 2/64, as shown in Figure 54. Director 2/64 Installation Guide 111