HP Surestore 64 FW 05.01.00 and SW 07.01.00 Director 2/64 Installation Guide ( - Page 65
Finalize the Rack Mounting Procedure, Positioning the switch in the rack
View all HP Surestore 64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Installing and Configuring the Director 2/64 Finalize the Rack Mounting Procedure Use the following sections to complete the installation procedure. After completing the steps outlined in the previous sections, install the switch in the rack as follows. WARNING: The Director 2/64 weighs approximately 115 pounds. Use proper handling and lifting equipment to reduce the possibility of injury or product damage. 1. Carefully position the switch in the front of the rack and onto the rail tray, and slide the switch back on the rails until the front mounting brackets are against the front rack columns. Figure 23 illustrates using a lifting jack to position the switch. Figure 23: Positioning the switch in the rack Director 2/64 Installation Guide 65