HP Surestore 64 FW 05.01.00 and SW 07.01.00 Director 2/64 Installation Guide ( - Page 66
Securing the switch to the rack, through the angle bracket and the rail
View all HP Surestore 64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
Installing and Configuring the Director 2/64 2. Mount the switch in the rack, as shown in Figure 24: a. On one side at the back of the switch, position an angle bracket (2) so that the threaded holes (1) are against the slots (5) of the rear mounting bracket and the angled side face out. b. Insert the screws (6) through the rear mounting bracket slots into the threaded nuts of the angle bracket. c. Insert a second set of screws (4) through the angle bracket and the rail column into the sheet metal nuts on the back rail (3). d. Repeat step a through step c for the other side at the back of the switch. e. At the front of the rack, insert the screws through the front mounting brackets into the sheet metal nuts installed in the rail columns in step 1 of "Prepare the Front and Rear Rack Columns" on page 62. f. Tighten all screws. Figure 24: Securing the switch to the rack 66 Director 2/64 Installation Guide