HP Surestore 64 FW 05.01.00 and SW 07.01.00 Director 2/64 Installation Guide ( - Page 87
Set the Director Online, Con Director Identification, Set Online State
View all HP Surestore 64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
Installing and Configuring the Director 2/64 Set the Director Online When the director is set online, an attached device can log into the director if the port is not blocked. Attached devices can communicate with each other if they are configured in the same zone. Use these steps to set the director online: 1. Open HAFM. The Products View page displays. 2. Double-click the appropriate director icon. The Hardware View page for the selected director displays. 3. Choose Maintenance > Set Online State. If the director is offline, the Set Online State dialog box displays, indicating the status is offline. 4. Click Set Online. A Warning dialog box displays, indicating status is online. 5. Click OK. The Status table displays Online. Set the Director Offline When the Director 2/64 is set offline, all ports are set offline. The director transmits the offline sequence (OLS) to attached devices, and the devices cannot log in to the director. Use these steps to set the director offline: 1. Notify the customer that the director is going offline. 2. Open HAFM. The Products View page displays. 3. Choose the appropriate director icon. The Hardware View page for the selected director displays. 4. Choose Maintenance > Set Online State. If the director is online, the Set Online State dialog box displays, indicating the status is Online. 5. Click Set Offline. A Warning dialog box displays, indicating the director will be set offline. 6. Click OK. Configure Director Identification Perform this procedure to configure the director name, description, location, and contact person for HAFM. The information displays in multiple dialog boxes throughout the application. In addition, the Name, Location, and Contact variables configured in the Configure Identification dialog box correspond respectively to the SNMP variables sysName, sysLocation, and sysContact. These variables are used by SNMP management workstations when obtaining data from managed directors. Director 2/64 Installation Guide 87