HP Surestore 64 FW 05.01.00 and SW 07.01.00 Director 2/64 Installation Guide ( - Page 79
LAN-Connect the Director, LAN-connect the director
View all HP Surestore 64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
Installing and Configuring the Director 2/64 LAN-Connect the Director Use these steps to connect the rack mounted director to the Ethernet LAN segment. 1. Connect one end of an Ethernet cable to the RJ-45 connector on each CTP2 card, as shown in Figure 35. 1 Remote workstation 2 Ethernet hub or switch (customer supplied) 3 HAFM server (laptop or rack mount) 4 Director 2/64 Figure 35: LAN-connect the director 2. Connect the remaining end of each Ethernet cable to the LAN as directed by the customer's network administrator. Note: If an HAFM server is not available, use the Embedded Web Server (EWS) interface. Attach the Ethernet LAN segment to an Internet connection and see Chapter 3. Director 2/64 Installation Guide 79
Installing and Configuring the Director 2/64
79
Director 2/64 Installation Guide
LAN-Connect the Director
Use these steps to connect the rack mounted director to the Ethernet LAN
segment.
1.
Connect one end of an Ethernet cable to the RJ-45 connector on each CTP2
card, as shown in
Figure 35
.
Figure 35:
LAN-connect the director
2.
Connect the remaining end of each Ethernet cable to the LAN as directed by
the customer’s network administrator.
Note:
If an HAFM server is not available, use the Embedded Web Server (EWS)
interface. Attach the Ethernet LAN segment to an Internet connection and see
Chapter 3
.
1
Remote workstation
2
Ethernet hub or switch (customer
supplied)
3
HAFM server (laptop or rack mount)
4
Director 2/64