Kyocera FS-1050 Service Manual - Page 110
Removing the separators, WARNING, Removing the separators
View all Kyocera FS-1050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
(1) Removing the separators WARNING The separation claws are extremely hot immediately after the printer was running. Allow substantial period of time until it cools down. 1. Remove and split the fuser unit (See page 5-20). 2. Loosen the stopper screws 1. 3. Hold the separators 2 upright, and remove the separators 2 and separator springs 3. Step 1 Step 2 1 2 2 3 Figure 5-2-21 Removing the separators FS-1050 5-22
FS-1050
5-22
(1) Removing the separators
WARNING
The separation claws are extremely hot immediately after the printer was running.
Allow substantial period of time until it cools down.
1. Remove and split the fuser unit (See page 5-20).
2. Loosen the stopper screws
1
.
3. Hold the separators
2
upright, and remove the separators
2
and separator springs
3
.
Figure 5-2-21 Removing the separators
1
2
3
2
Step 1
Step 2