Kyocera FS-1050 Service Manual - Page 58
Confirm that the status shows the new system firmware version See
View all Kyocera FS-1050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
5 Data are transferred to the RAM on the main board. 6 The system DIMM or Flash ROM is overwritten with the new firmware data. 7 Firmware download is finished. (When more than one data are down loaded, the data display can be changed by pressing any key. 8 Turn power switch off. 9 Remove the memory card and then secure the slot cover by using two screw. 0 Turn power switch on. ! Check the printer gets Ready. From the previous page 4 Message display Supervisor mode 5 Supervisor mode CF-CARD Reading 6 BootROM erase&write 9 DIMM erasing #?? DIMM writing
3-13
FS-1050
5
Data are transferred to the RAM on the main board.
6
The system DIMM or Flash ROM is overwritten with the new firmware data.
7
Firmware download is finished. (When more than one data are down loaded, the data display
can be changed by pressing any key.
8
Turn power switch off.
9
Remove the memory card and then secure the slot cover by using
two screw.
0
Turn power switch on.
!
Check the printer gets Ready.
Confirm that the status page shows the new system firmware version (See
Appendix B
on page B-
4). If the message display indicates download error, refer to section
Downloading errors
on page 3-
14.
Supervisor mode
CF-CARD Reading
BootROM
erase&write
DIMM erasing #??
Ready
Power switch: Off
Power switch: On
B
A
C
D
E
80.00S
01/08/07[1234] 2
End
DIMM writing
<<<<<<<<<<u
7
8
!
0
4
5
6
9
From the previous page
Supervisor mode
Message display
Memory
card
A
:
u
= Extracting
W
= Writing
V
= Verifiying
B
: Version
C
: Year/Month/Day
D
: [Checksum]
E
: Means more than one data
: Shows only included
firmeware of boot program
(".bcmp" extension file).