Kyocera FS-1050 Service Manual - Page 168
Parallel interface pin assignment
View all Kyocera FS-1050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 168 highlights
Parallel interface pin assignment The pins of the parallel interface connector carry the signals listed below. The function for each signal is detailed on the following page. 18 1 36 19 No. Terminal Signal No. Terminal 1 nStrobe (STBIN1/2*) 19 Ground 2 Data1 (PAD0) 20 Ground 3 Data2 (PAD1) 21 Ground 4 Data3 (PAD2) 22 Ground 5 Data4 (PAD3) 23 Ground 6 Data5 (PAD4) 24 Ground 7 Data6 (PAD5) 25 Ground 8 Data7 (PAD6) 26 Ground 9 Data8 (PAD7) 27 Ground 10 nAck (ACKOUT) 28 Ground 11 Busy (BUSYOUT) 29 Ground 12 PError (PERROR) 30 Ground 13 Select (SELECT) 31 nInit 14 nAutoFd (AUTOFD*) 32 nFault 15 Not defined NC 33 Not defined 16 Logic ground GND 34 Not defined 17 Chassis ground GND 35 Not defined 18 Peri-logic H (VCC) 36 nSelect In Maximum rated current for pin 18 is 400 mA (fused). Signal GND GND GND GND GND GND GND GND GND GND GND GND (INIT*) (FAULT*) Pull-up (1kΩ) NC Pull-up (1kΩ) (SELECTI*) FS-1050 C-4