Kyocera FS-1050 Service Manual - Page 129
Call service 2010 - Main motor error
View all Kyocera FS-1050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
(3) Call service 2010 - Main motor error Call service 201C0all service 2010 Remove and check harness (S02773) between engine board (KP-882) and main motor at pins 6 to 9 on both ends. No OK? Yes +24 V DC at pin No 9 of CN1 on main motor? Yes Connect circuit tester to pin 8 (MOTORN) of YC04 on engine board (KP-882) and ground. Turn printer power off, then on. Replace harness (S02773) between engine board (KP-882) and main motor. Connect oscilloscope to pin 8 (MOTORN) and pin 7 (MRDYN) of CN1 on main motor. Print status page. Turn power switch off, then on. Does pin 8 (MOTORN) Yes of YC04 on engine board (KP-882) goes high, then low? No No Replace engine board (KP-882). See page 5-11. Print status page. Does pin 7 (MRDYN) of CN1 on main motor goes high, then low, within 3 seconds from pin 8 (MOTORN) goes low? Yes Replace main motor. See page 5-15. If not solved, check or replace drive unit. See page 5-16. 6-9 FS-1050