Kyocera FS-1050 Service Manual - Page 170
USB interface
View all Kyocera FS-1050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 170 highlights
USB interface This printer supports the USB (Universal Serial Bus) Revision 1.1 standards. USB interface specifications and interface signals are as follows: Item Basic specification Connectors Cable Transfer mode Power control Specifications Complies with the USB Revision 1.1 standards. Printer: B-type receptacle (female) with upstream port Cable: B-type plug (male) Use shielded cable that complies with the USB Revision 1.1 standards and not longer than 5 meters (16 feet). Full speed (max. 12 Mbps) Self-power device USB interface pin assignment 21 34 Shell No. Signal Description 1 Vbus Power supply (+5 V) 2 D- Data transmission 3 D+ Data transmission 4 GND Signal ground Shell Shield Shell: Shield FS-1050 C-6
C-6
FS-1050
USB interface
This printer supports the USB (Universal Serial Bus) Revision 1.1 standards. USB interface
specifications and interface signals are as follows:
Item
Specifications
Basic specification
Complies with the USB Revision 1.1 standards.
Connectors
Printer: B-type receptacle (female) with upstream port
Cable: B-type plug (male)
Cable
Use shielded cable that complies with the USB Revision 1.1 standards and
not longer than 5 meters (16 feet).
Transfer mode
Full speed (max. 12 Mbps)
Power control
Self-power device
No.
Signal
Description
1
Vbus
Power supply (+5 V)
2
D-
Data transmission
3
D+
Data transmission
4
GND
Signal ground Shell Shield
Shell: Shield
USB interface pin assignment
2
1
3
4
Shell