Kyocera FS-1050 Service Manual - Page 30
Locking the toner container
View all Kyocera FS-1050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
7. Push the lock lever #1 1 to the lock position. 8. Close the top cover 4. 1 4 LOCK UNLOCK LOCK UNLOCK NOTE Figure- 2-2-5 Locking the toner container The printer is shipped from the factory with no toner supplied in its developer (Process unit). When the printer is first switched on after the toner container is installed in the manner above, there will be a delay of several minutes before the printer gets ready to print a job. This delay is necessary for the printer to fill the developer reservoir with a sufficient amount of toner to continuously support a print job. The period of time is approximately 15 minutes. If the toner low or replace toner indication does not go off after installing the new toner container, take the toner container out once, shake it well, then install again. FS-1050 2-7