Kyocera FS-1050 Service Manual - Page 172
interface board
View all Kyocera FS-1050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 172 highlights
Remove two thumb screws 1 then draw the serial interface board 2. To change the serial protocol from RS-232C to RS-422A, for example, carefully remove the jumper connector 3 on the serial interface board 2. Reconnect to the pin position as shown in the diagram. Replace the serial interface board 2 back into the printer. Secure the board by the thumb screws. 3 FS-1050 1 2 C-8
C-8
FS-1050
Remove two thumb screws
1
then draw the serial interface board
2
. To change the serial protocol
from RS-232C to RS-422A, for example, carefully remove the jumper connector
3
on the serial
interface board
2
. Reconnect to the pin position as shown in the diagram. Replace the serial
interface board
2
back into the printer. Secure the board by the thumb screws.
2
1
3