Lexmark T620 Service Manual - Page 187

4069-5XX/7XX Twelfth Sheet: Bin #10, then the order reverses from Bin #9 to the Standard Bin. 4. The test is continuous until either the Return or Stop button is pressed. Output Bin Feed Test Note: If the "Configure Bins" printer setting is link rather than mailbox, the printer selects its own internal bin linking regardless of which output bin is selected for the feed test This test is used to verify that media can be fed to a specific output bin. No information is printed on the media fed to the output bin because the printhead is not turned on during this test. This test can be run from any input source and will support any size paper or envelope supported by the printer. To run the Output Bin Feed Test: 1. Select Feed Test from the Output Bin Test menu. 2. Select the output bin you want the paper to exit into. The standard bin as well as any output option bin installed on the printer is shown on the menu. (The output bin displayed is in the order installed on the printer.) 3. Select either Single (one sheet of media feeds to the selected output bin) or Continuous (media continues feeding to the selected output bin) until Return/Stop is pressed. 4. Press Return/Stop to exit the test. Output Bin Sensor Test This test is used to determine whether or not the output bin sensor is working correctly for the Standard Bin or the sensors are working for the Output Expander, High Capacity Output Stacker, 5 Bin Mailbox or StapleSmart Finisher Options if installed. To run the Output Bin Sensor Test for: Diagnostic Aids 3-21