Lexmark T620 Service Manual - Page 209

4069-5XX/7XX Error Message 28x Paper Jam (x=StapleSmart Finisher) Error Message 280 - Check Finisher or Error Message 281 - Check Finisher When either of these two messages are displayed, they indicate that paper is jammed in the finisher option. Open the finisher rear door and top cover to remove the jam. Note: If the paper is still covering the finisher pass thru sensor, then a 271 Error Message is displayed. A 281 paper jam message may also be displayed when there is a problem with the stapler assembly or the stapler card. Note: When the StapleSmart Finisher option is installed, a secondary message may be displayed which advises whether or not to remove the job from the finisher. If a job has accumulated in the finisher, then the printer alternately flashes the primary and secondary messages to indicate that all accumulated sheets should not be removed during the jam clearance procedure. If the sheets are removed, then the printer does not reprint these sheets. Error Message 282 - Check Stapler This message indicates that a staple jam has been detected during normal operation, when printing and stapling jobs. The printer alternately flashes the primary and secondary message to indicate that all accumulated sheets should be removed during the jam clearance procedure. Error Message 283 - Check Stapler This message indicates that a staple jam has been detected during a stapler priming operation. There is no secondary message displayed. Note: After the error has been cleared, the printer does not reprint any pages which existed in the accumulator for stapling. Note: Use of the Sub Error chart should be used to help diagnose problems when 281, 282, and 283 are displayed. Diagnostic Aids 3-43