Lexmark T620 Service Manual - Page 277
Connector Locations, A 902 service error may display if the jumpers are not, correctly installed.
View all Lexmark T620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 277 highlights
4069-5XX/7XX Connector J5 Autoconnect BTM/FNT J7 system board J11 INA 1 J12 INA 2 Pin No. 1 2 1 1 1 Signal +24 V dc Ground N/A N/A N/A Connector J8 ID-1 J9 ID-2 J10 ID-3 Jumper Position 1 2 3 4 5 6 Signal 0 V dc (Gnd) center pin to top pin of J8 + 5 V dc center pin to bottom pin of J9 0 V dc (Gnd) center pin to top pin of J9 +5 V dc center pin to bottom pin of J9 0 V dc (Gnd) center pin to top pin of J10 +5 V dc center pin to bottom pin of J10 Note: A 902 service error may display if the jumpers are not correctly installed. Connector Locations 5-5
Connector Locations
5-5
4069-5XX/7XX
Note:
A 902 service error may display if the jumpers are not
correctly installed.
J5 Autoconnect
BTM/FNT
1
+24 V dc
2
Ground
J7 system board
1
N/A
J11 INA 1
1
N/A
J12 INA 2
1
N/A
Connector
Jumper
Position
Signal
J8 ID-1
1
0 V dc (Gnd) center pin
to top pin of J8
2
+ 5 V dc center pin to
bottom pin of J9
J9 ID-2
3
0 V dc (Gnd) center pin
to top pin of J9
4
+5 V dc center pin to
bottom pin of J9
J10 ID-3
5
0 V dc (Gnd) center pin
to top pin of J10
6
+5 V dc center pin to
bottom pin of J10
Connector
Pin No.
Signal