Lexmark T620 Service Manual - Page 49

4069-5XX/7XX Stacker Sub Error Codes First 6 Bytes Sub Error Code Data - Note: xx can be any value Explanation 84 xx 14 There is media in stacker 1 during POST. Usually associated with a 271 Paper Jam Error message. May be displayed when a finisher option is installed in lowest or first position above the printer. If present, remove the media from stacker 1. If the error continues to be displayed or there is no media present in the stacker, check the pass thru sensor and flag of stacker 1 or, if installed, check the option below stacker 1. 84 xx 15 There is media in stacker 2 during POST. If present, remove the media from stacker 2. If the error continues to be displayed, or there is no media present in the stacker, check the pass thru sensor and flag of stacker 2, or check the option below stacker 2. 84 xx 16 There is media in stacker 3 during POST. If present, remove the media from stacker 3. If the error continues to be displayed, or there is no media present in the stacker, check the pass thru sensor and flag of stacker 3, or check the option below stacker 3. 95 xx 00 x1 x2 Stacker sensor x never became uncovered. (x1=sensor's stacker, x2=stacker destination) Check stacker x to see if a piece of paper is over the sensor. If not, check to see if the sensor and flag are working correctly. 95 xx 01 x1 x2 Stacker sensor x never was covered or actuated. (x1=sensor's stacker, x2=stacker destination) Check stacker x to see if the sensor and flag are operating correctly. 98 xx 02 x1 x2 x3 Stacker x did not indicate that a page had been received in the output. (x1=stacker destination) Diagnostic Information 2-21