Lexmark T620 Service Manual - Page 198
Restore EP Factory Defaults, Configuration ID. If the ID is invalid then INVALID ID message
View all Lexmark T620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 198 highlights
4069-5XX/7XX - The current ID displays on the screen. The Configuration ID is on a label located inside the printer. The label is attached to the top front cover hinge assembly and is visible when the top front cover is open. - The leftmost digit blinks indicating that it is the first digit to be changed. 3. To change the value, press either Menu until the value you want is reached. Press Select to move to the next digit, or press Select again to skip a digit. Change each digit as required. When the last digit is changed, press Select to validate the Configuration ID. If the ID is invalid then "INVALID ID" message displays on Line 2 before the ID redisplays. Reenter the Configuration ID until a valid ID is verified. If the ID is valid then the ID is saved in NVRAM and the printer automatically PORs to activate the new setting. Note: When the printer PORs it does so in the normal mode. Restore EP Factory Defaults To restore each of the printer settings contained in the EP Setup menu to their factory default value select Restore from the menu. To exit the menu without restoring the settings to the factory default values, select Do Not Restore. Sometimes this is used to help correct print quality problems. Fuser Temperature This adjustment can be used to help solve some customer problems with paper curl on low grade papers or problems with letterheads on some types of media. The fuser temperature can be adjusted as follows: • NORMAL • LOWER • LOWEST Warm Up Time You can change the amount of time the printer warms up before allowing pages to print by changing this setting from 0 to 5. The factory sets the warm up at 0 or no warm up time. This time period 3-32 Service Manual