Brother International HE-800B Instruction Manual - English - Page 42
Program setting method, Program mode is not available if a cycle program has been
View all Brother International HE-800B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
5. USING THE SEWING MACHINE (OPERATION PANEL: BASIC OPERATION) 5-4. Program setting method It is recommended that you register patterns that are sewn frequently as programs. After programs have been registered, you can retrieve the desired sewing patterns simply by selecting a program number, which eliminates the need to set the pattern each time. • Normally up to 50 programs can be registered, and their contents can be changed at any time. The contents can be set by changing the parameters for each item. • At the time of shipment from the factory, temporary contents are set for programs P01 to P50. (The contents are the same for all programs from P01 to P50.) Follow the method given below to change the contents of a program before using it. 1 Switch the mode to test feeding mode. 4785M 2 Select the program number from P01 to P50 (1) to select the program that you would like to change. 4786M Independent program Cycle program (Refer to P. 52) 4787M 3 Switch to program mode. The program No. (1) changes in the order shown in the illustration each time the key is pressed. (The key changes the order in the opposite direction.) NOTE: Program mode is not available if a cycle program has been selected. 4788M 4789M The parameter number (2) that was last selected and the setting (3) for that parameter will appear in the display. * You can also start program mode by pressing a shortcut key. In this case, the parameter number that corresponds to the shortcut key will be selected. (Refer to the next page.) 4918M 33 HE-800B