Brother International HL-1070 Technical Reference - Page 134
COLOR MODES, Using Simple Color Mode - Set Simple Color
View all Brother International HL-1070 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 134 highlights
2001/10/02 2. COLOR MODES The PCL5C emulation provides a B/W mode, which is the default, and three color modes as follows; 1) Simple Color Mode 2) PCL Color Mode 3) HP-GL/2 Color Mode Simple Color Mode allows you to use a maximum of 8 colors easily. PCL Color Mode allows you to use a maximum of 16,000,000 colors logically. HP-GL/2 Mode allows you to use vector graphics in color. It is possible to switch between these modes in a single page, which enables you to use each of them for your purpose. When handling colors in those modes, use palette. For details on palette, refer to Section 3 'Color Palettes' of this chapter. This section describes the details about each color mode. 2.1. Using Simple Color Mode - Set Simple Color Command ESC*r#U (27)(42)(114)#(85) # # = -4 CMYK mode # = -3 CMY mode # = 1 B/W mode * # = 3 RGB mode * Default value = 1 • The # value specifies the palette and the colors for the palette. For specific colors, refer to the table below; • This command specifies each color corresponding to the index number. The color is fixed and unchangeable. • The colors which were specified in the palette by the PCL or HP-GL/2 command are cancelled. Index No 0 1 2 3 4 5 6 7 * = default -4 (CMYK) White Cyan Magenta Blue Yellow Green Red Black -3(CMY) White Cyan Magenta Blue Yellow Green Red Black 1(B/W) * White Black - 3(RGB) Black Red Green Yellow Blue Magenta Cyan White CHAPTER 3 "PCL5C" - 4