Brother International HL-1070 Technical Reference - Page 242
Status Readback Commands, Inquire, Pjl Set, Pjl Default, Pjl Initialize, Ustatus, Pjl Dinquire
View all Brother International HL-1070 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 242 highlights
2001/10/02 7. STATUS READBACK COMMANDS 7.1. Introduction Applications can request, by sending a PJL command to the printer, information such as the configuration and status of the printer. The printer can be programmed to send back this information when requested and also can send back voluntarily unsolicited information of its status such as cover open, off-line state, toner empty, displayed prompt message on the LCD and other necessary information. PJL Status Readback will help you to program the application to appropriately set the printer settings. In this chapter, you can learn how to use PJL Status Readback in programming an application. The following Status Readback Commands are described : • INQUIRE ... requests the information of the specified PJL Default setting (PJL Current Environment) set by @PJL SET or @PJL RESET command • DINQUIRE ... requests the information of the specified User Default setting (User Default Environment) set by @PJL DEFAULT or @PJL INITIALIZE command or control panel • ECHO ... request the printer to send back to the host computer a comment for the purpose of synchronization with each other in order to start communication • INFO ... requests a specified category of information from the printer • USTATUS ... gives the printer permission to send back unsolicited information. • USTATUSOFF ... turns off all unsolicited status information set by USTATUS Job Recovery is also described in this chapter. 7.1.1. Synchronization with the printer The printer sends the status responses to the same I/O port as it received the request from. Therefore, in a shared or network environment, if the I/O port was used by another user and the printer is still processing the previous job, the printer may send a response of the status of the previous user's job against the request from the current application. In order to make sure that an application can receive correct responses for its request, it must synchronize itself with the printer by sending the ECHO command so as to be assured that the printer is ready for communication to you. 7.1.2. Basic format of status readback responses The printer sends its status information to the host computer in the following format : • starts with t he @PJL prefix • ends with a character • All the data is in a readable ASCII format. Each line in the PJL status responses is in the following format : • starts with a specific keyword • ends with For example, the readback response against the @PJL DINQUIRE is : @PJL DINQUIRE [LPARM : personality] variable value The application must read all the data between the @PJL and codes. If the application can not understand the meaning of the lines, it must ignore them. Future printers may send currently unused keywords. Refer to each command description to learn about the format of responses from the printer. CHAPTER 5 PJL - 38