Home » Brother International Manuals » Laser Printers » Brother International HL-1070 » Manual Viewer

Brother International HL-1070 Technical Reference - Page 416

COMMAND TO ENTER HBP MODE, Command, Function, Explanation

View all Brother International HL-1070 manuals

Add to My Manuals
Save this manual to your list of manuals

Page 416 highlights

2001/10/02 2. COMMAND TO ENTER HBP MODE Command %-12345X@PJL @PJLENTERLANGUAGE=HBP Function The printer enters the HBP mode when this command is received. Explanation The printer can receive this command when it is in the idle condition (during HP emulation, IBM emulation, Epson emulation and Auto emulation for HL-1040). The printer reports an error if it receives this command when it is already in HBP mode. The printer enters HBP mode when it receives this command. This mode continues until one of following occurs. (1) The printer receives the Exit command. (2) The printer power is turned off. (3) InputPrime Signal is brought LOW. The printer executes the following HBP commands in HBP mode. APPENDIX C HBP MODE COMMANDS - 4

Section	Page
TABLE OF CONTENTS	3
GLOSSARY	5
CHAPTER 1 INTRODUCTION	15
CONTENTS	16
CHAPTER 2 PCL	21
CONTENTS	22
COMMAND LIST	27
INDEX	128
CHAPTER 3 PCL5C	131
CONTENTS	132
INDEX	148
CHAPTER 4 HP-GL/2	149
CONTENTS	150
INDEX	202
CHAPTER 5 PJL	205
CONTENTS	206
INDEX	262
CHAPTER 6 EPSON FX-850	264
CONTENTS	265
COMMAND LIST	266
INDEX	293
CHAPTER 7 IBM PROPRINTER XL	294
CONTENTS	295
COMMAND LIST	296
INDEX	314
CHAPTER 8 BAR CODE CONTROL	316
CONTENTS	317
CHAPTER 9 HP-GL	326
CONTENTS	327
COMMAND LIST	328
INDEX	352
APPENDIX A COMPARISON LIST	353
CONTENTS	354
APPENDIX B FLASH/PCMCIA CARD COMMANDS	395
CONTENTS	396
APPENDIX C HBP MODE COMMANDS	413
CONTENTS	414
APPENDIX D REFFERENCE LIST OF MX-2000/4000/5000 SERIES UNIQUE COMMANDS	427
CONTENTS	428
APPENDIX E REFFERENCE LIST OF FS-5050 UNIQUE COMMANDS	436