Brother International HL-1070 Technical Reference - Page 200
SB - Scalable or bitmap fonts, ES - Extra space, TD - Transparent data, HP-GL/2 - 52
![]() |
View all Brother International HL-1070 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 200 highlights
2001/10/02 10 ' -Character Slant20 WIDTH "LPT1:", 255 30 LPRINT CHR$(27); "E"; 40 LPRINT CHR$(27; "%0B"; 50 LPRINT "IN;SP1;"; 60 LPRINT "SD1,21,2,1,4,25,5,0,6,0,7,5;SI0.7,1;" 70 LPRINT "PA1000,1000;DT#,1;SL0.36,LBPrinter#" 80 LPRINT "PA1000,300;SL-0.36;LBPrinter#" 90 LPRINT CHR$(27); "%0A"; 100 LPRINT CHR$(27); "E"; 110 END SB - Scalable or bitmap fonts SB [ n ] [;] n : font category selection • This command enables you to restrict the range of selectable fonts to scalable fonts and the stick font only. • n can be 0 or 1. If n = 0 you may only select scalable fonts (or the stick font). If n = 1 you may select any type of font. • An SB command can alter the current standard and alternate font selections. • Setting n to 1 allows the selection of bitmapped fonts and has the following side-effects: • Bitmap characters cannot be edged. • Bitmap characters can only be printed in orientations of 0°, 90°, 180° or 270°. • The SL (character slant) command is not applied to bitmap fonts. • Bitmap font character sizes are approximate only. • The DF and IN commands set n to 0, - only scalable fonts and the stick fonts may be selected. • The FI and FN commands implicitly set n to 1 if you use either of them to select a bitmap font. • If you omit n from the command, only scalable fonts and the stick font may be selected. This is equivalent to an SB0; command. • The default setting is scalable fonts and stick font only. ES - Extra space ES [ width [,height]] [;] width : factor by which character spacing is changed. height : factor by which line spacing is changed • This command enables you to adjust the space between label characters and lines. • width specifies the factor by which to increase or decrease the character spacing. Positive numbers specify an increase and negative numbers a decrease. • height specifies the factor by which to increase or decrease the line spacing. Positive numbers specify an increase and negative numbers a decrease. • If you use the command without parameters, no extra space is used when labels are printed. This is equivalent to ES0,0; • An ES command remains in effect until another ES command is executed, a DF or IN command is executed or the printer is reset, either with the EscE command or from the control panel. TD - Transparent data TD [ mode ] [;] mode : normal or transparent data mode. • This command enables you to specify whether control characters should perform their normal function or should be printed. CHAPTER 4 HP-GL/2 - 52
![](/manual_guide/products/brother-international-hl1070-technical-reference-329cc8c/200.png)