Brother International HL-1070 Technical Reference - Page 418

2001/10/02 3.2 Commands (Detailed Explanation) 3.2.1 Resolution setting commands Command @L + * Function This command sets the printer resolution. Command @ L+ (00000000)B @ L+ (00000101)B @ L+ (00001010)B Resolution 600dpi 300dpi 150dpi (Default) Explanation The resolution is set when the printer receives this command. This command is applied from the next page printed after the FormFeed command after this command is sent (i.e. the next complete page). The resolution is valid until the one of the following occurs. (1) The printer receives the Exit command. (2) The printer power is turned off. (3) InputPrime Signal is brought LOW. After (1) is sent, the printer resolution is uncertain. The driver must resend this command again after the HBP mode switch command is sent. After (2) or (3), the resolution returns to default (600 dpi). 3.2.2 Economy mode setting commands Command @E + * Function Command @ E+ (00000000)B @ E+ (00000001)B @ E+ (00000010)B @ E+ (00000011)B Economy Mode OFF (Default) Level 1 (Darkest) Level 2 Level 3 (Lightest) Explanation This command is applied from the next page printed after the FormFeed command after this command is input. Default value is Economy Mode OFF. The ECONOMY MODE is valid until the one of the following occurs. (1) The printer receives the Exit command. (2) The printer power is turned off. (3) InputPrime Signal is brought LOW. After (1) is sent, the ECONOMY MODE value is uncertain. The driver must resend this command again after the HBP mode switch command is sent. After (2) or (3), the ECONOMY MODE value returns to default. (OFF) APPENDIX C HBP MODE COMMANDS - 6