Brother International HL-1070 Technical Reference - Page 421
J+chr$ 0 +chr$ N, K+chr$ 0, Appendix C Hbp Mode Commands - 9
View all Brother International HL-1070 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 421 highlights
2001/10/02 3.2.5 Engine related setting commands Command @J+* Function This command allows the setting of engine related commands. Each setting depends on the value of the 3 byte command string. @J+CHR$ (0) +CHR$ (n): Sets Media Type This command allows the printer to change the temperature control for the fuser unit when printing. n=0: Regular (Default) n=1: Thick paper n=2: Thicker paper n=3: Transparency @J+CHR$ (1) +CHR$ (n): Sets the toner stirring time The value of n (0-255) sets the toner stirring time in seconds. The value 0 gives the default setting of 30 seconds stored in the printer, and 1- 6 is fixed at 6 seconds. Toner is stirred by the @K+CHR$ (0) command. It is not necessary to set it from the driver. @J+CHR$ (2) +CHR$ (n): Indicates Envelope mode n=0 Normal mode n=1 Envelope mode The driver sets the value to 1 if the paper length is from 180 mm to 250 mm, and the value to 0 when it is shorter or longer. @J+CHR$ (3) +CHR$ (n): Sets the envelope mode level The value n sets the time limit in continuous envelope printing. The default (0) is 20 seconds, which represents a printing speed of 3 ppm. When set to 0, the time limit in continuous envelope printing is set to 20 seconds. The printing speed is fastest if the setting is shorter than normal loading speed, such as 1 second or 2 seconds. It is not necessary to set it from the driver. 3.2.6 Engine related execute commands Command @K+* Function This is an immediately executed command. @K+CHR$ (0): Execute toner stirring To set the toner stirring time, use the command, @J+CHR$(1)+CHR$(n). It is not necessary to set this command from the driver. APPENDIX C HBP MODE COMMANDS - 9