Brother International MFC-7400C Users Manual - English - Page 55

Setting Volume Amplify Please carefully read Choosing the Handset Volume, page 5-4 before you do the following steps: 1 Press Function, 1, 1, 4. 2 If none of the users are hearing-impaired, press or to select VOL VOL AMPLIFY:ON? AMPLIFY:OFF? and press Set, then SELECT & SET go to Step 4-OR-If some or all of the users are hearing-impaired, select VOL AMPLIFY:ON? and press Set. 3 If all the users are hearing-impaired, press or to select PERMANENT? and press Set-OR- If only some of the users are hearingimpaired, select TEMPORARY? and press Set. PERMANENT? SELECT & SET TEMPORARY? SELECT & SET 4 Press Stop to exit. Setting the Speaker Volume You can adjust the speaker volume when your machine is onhook (after the machine is onhook dialing). You can turn the speaker off or you can select a speaker volume level. The default setting is the lowest volume. Press or to adjust the volume level. The display shows the setting you are choosing. Each key press changes the volume to the next setting. The new setting will remain until you change it again. Setting the Ring Volume You can adjust the ring volume when your MFC is idle. You can turn the ring OFF or you can select a ring volume level. Press or to adjust the volume level. With each key press, the MFC rings so you can hear the current setting and the display shows the setting you are choosing. Each key press changes the volume to the next setting. The new setting will remain until you change it again. Memory Storage In the event of a power failure, all settings in the INITIAL SETUP, SETUP RECEIVE, SET AUTO DIAL, REMOTE FAX OPT, plus the COVERPG SETUP and COVERPAGE MSG functions (from SETUP SEND) are stored permanently. You may have to reset the date and time. INITIAL SETUP 5-5