Canon imageFORMULA ScanFront 400 Instruction Manual - Page 201

Chapter 9 Troubleshooting There is no file name specified. Enter a file name or enable the 'Auto file name' setting. Failed to send the files. You can't use following character for File name. Can not create folder. A character that cannot be used for a host name is included. You can't choose JPEG when Binary Mode is selected. Cause Solution Cause Solution Cause Solution Cause Solution Cause Solution Cause Solution Cause Solution Cause Solution A file name was not entered and "Auto file name" is set to [None]. Enter a file name or set "Auto file name" to other than [None]. (See p. 98.) The destination is incorrect, or connection to the destination cannot be established. Check whether the host name, FTP server, email address, or folder path registered as the destination is correct, and check whether connection to the destination is possible. Attempting to send a single 10 MB or larger image file. Reduce the size of the scanned document so that the image file is less than 10 MB. Attempting FTP sending without using the passive mode. Enable the passive mode on the FTP registration screen. (See p. 81.) Invalid characters have been used to set the custom file name. Make sure the custom file name does not contain any of the following characters The USB memory device is not connected properly. Check the connection of the USB memory device. An invalid character exists in the specified host name. Do not use the following characters when the specifying host names. /:?*"| The scanner cannot be used with the selected mode and file format combination. Check which mode and file format combinations can be used. (See p. 87.) 201