Canon imageFORMULA ScanFront 400 Instruction Manual - Page 85

Chapter 4 Operating Procedures 8. Scan / Send Settings This section describes the scan settings and send settings for the scanner. i a e j b f g c h d k a Address Display Area Displays the selection that you made on the address selection screen or the addresses registered to the job button. b File format Checks the displayed file format and press the [File format] button to configure the settings. (See "File Formats" on p. 95.) c Send Settings Sets the send conditions. (See "Send Settings" on p. 98.) d [Back] button Returns the display to the previous screen. e Details Displays detailed information for the address with the colored background. f [Deskew] button The scanner detects from the scanned image that the document was fed askew and then straightens the image. g [Prescan] button When scanning starts, the first page of the document is scanned and then scanning stops. You can view the image of the first page to check and adjust the brightness and contrast before scanning the entire document. Hint • Scanning pauses after the first page of the document is scanned, and the image of the first page is displayed. • Use the displayed image to confirm and adjust the brightness and contrast. Press [Continue] to confirm the adjusted brightness and contrast for the first image and continue scanning. h [Default] button Resets any modified settings to the default values of the scanner. IMPORTANT If you press [Default] in the Scan / Send Settings screen opened from a job button, the settings are reset not to the setting values registered to the job button, but to the default values of the scanner. 85