Cisco ISE Software Configuration Guide - Page 38
Configuring ATM Cell Relay over MPLS on PVCs, DETAILED STEPS, Example, Restrictions
UPC - 746320730097
View all Cisco ISE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
How to Configure AToM VCs on the 4-Port ATM ISE Line Card Software Configuration of ATM ISE Line Cards for Cisco 12000 Series Routers DETAILED STEPS Step 1 Command enable Step 2 Example: Router> enable configure terminal Purpose Enables privileged EXEC mode. • Enter your password if prompted. Enters global configuration mode. Step 3 Example: Router# configure terminal interface atmslot/port Specifies an ATM interface. Step 4 Step 5 Step 6 Example: Router(config)# interface atm1/0 pvc vpi/vci l2transport Example: Router(config-if)# pvc 1/200 l2transport Assigns a virtual path identifier (VPI) and virtual circuit identifier (VCI). The l2transport keyword indicates that the PVC is a switched PVC and not a terminated PVC. encapsulation aal5 Specifies ATM AAL5 encapsulation for the PVC. Make sure you specify the same encapsulation type on the PE and CE routers. Example: Router(config-atm-l2trans-pvc)# encapsulation aal5 xconnect peer-router-id vcid encapsulation Binds the attachment circuit to a pseudowire VC. mpls Example: Router(config-atm-l2trans-pvc)# xconnect 13.13.13.13 100 encapsulation mpls Example Router> enable Router# configure terminal Router(config)# interface atm1/0 Router(config-if)# pvc 1/200 l2transport Router(config-atm-l2trans-pvc)# encapsulation aal5 Router(config-atm-l2trans-pvc)# xconnect 13.13.13.13 100 encapsulation mpls Configuring ATM Cell Relay over MPLS on PVCs Perform this task to configure ATM Cell Relay on permanent virtual circuits (PVCs). Restrictions The cell relay function can only be configured when the ATM VC is configured for AAL0 encapsulation. It has no meaning if the VC is configured with AAL5 encapsulation. Cisco IOS Release 12.0(27)S 38