Cisco ISE Software Configuration Guide - Page 57

Software Configuration of ATM ISE Line Cards for Cisco 12000 Series Routers How to Configure AToM VCs on the 4-Port ATM ISE Line Card Command or Action Step 14 vbr-rt pcr scr burst Example: Router(config-if-vc)# vbr-rt 2000 1000 100 Purpose Specifies VBR-rt shaping. The pcr value indicates the peak cell rate, and its range is from 38 to 622000 Kbps. The scr value indicates the sustainable cell rate, and its range is from 38 to pcr Kbps. The burst value indicates the burst size, in number of cells. Step 15 service-policy output policy-map-name Note In place of the vbr-rt command, you can use the ubr, cbr, or vbr-nrt commands to configure UBR, CBR, or VBR-nrt shaping in the same way. Attaches the queue-limit service policy to the PVC. Step 16 Example: Router(config-pmap-c)# service-policy output out_vbr-rt xconnect peer-router-id vcid encapsulation mpls Binds the attachment circuit to a pseudowire VC. Example: Router(config-atm-vc)# xconnect 2.2.2.2. 121 encapsulation mpls Example Router> enable Router# configure terminal Router(config)# policy-map out_vbr-rt Router(config-pmap)# class class-default Router(config-pmap-c)# queue-limit 300 cells Router(config-pmap-c)# exit Router(config-pmap)# exit Router(config)# interface atm1/0 Router(config)# atm clock internal Router(config-if)# atm mcpt-timers 100 1000 5000 Router(config-if)# pvc 21/21 l2transport Router(config-atm-l2trans-pvc)# encapsulation aal0 Router(config-atm-l2trans-pvc)# cell-packing 10 mcpt-timer 1 Router(config-if-vc)# vbr-rt 2000 1000 100 Router(config-pmap-c)# service-policy output out_vbr-rt Router(config-atm-vc)# xconnect 2.2.2.2. 121 encapsulation mpls Configuring Cell Packing over MPLS on PVPs The following task illustrates the configuration of VBR-NRT traffic shaping in cell packing over MPLS in VP mode: SUMMARY STEPS 1. enable 2. configure terminal 3. policy-map policy-map-name Cisco IOS Release 12.0(27)S 57