Cisco ISE Software Configuration Guide - Page 71

Software Configuration of ATM ISE Line Cards for Cisco 12000 Series Routers How to Configure AToM VCs on the 4-Port ATM ISE Line Card Step 8 Command or Action police rate scr cps atm-mbs mbs cells conform-action transmit exceed-action drop Step 9 Example: Router(config-pmap-c)# police rate 100000 cps atm-mbs 1024 cells conform-action transmit exceed-action drop exit Purpose Specifies a maximum bandwidth usage by a traffic class through the use of a token bucket algorithm. For a description of the conform-action and exceed-action keywords, see Table 5 on page 16. Exits class mode. Step 10 Example: Router(config-pmap-c)# exit exit Exits policy map mode. Step 11 Example: Router(config-pmap)# exit policy-map vbr3 Specifies the name of the parent service policy to configure. Step 12 Example: Router(config)# policy-map vbr3 class class-default Specifies to configure the default class. Step 13 Example: Router(config-pmap)# class class-default set mpls experimental mpls-exp-value Example: Router(config-pmap-c)# set mpls experimental 4 (Optional) Specifies the value used to set the MPLS EXP bits defined by the policy map. Valid values are numbers from 0 to 7. Step 14 police rate pcr cps delay-tolerance cdvt conform-action transmit exceed-action drop Example: Router(config-pmap-c)# police rate 250000 cps delay-tolerance 10 conform-action transmit exceed-action drop Specifies a maximum bandwidth usage by a traffic class through the use of a token bucket algorithm. For a description of the conform-action and exceed-action keywords, see Table 5 on page 16. Step 15 service-policy child-vbr3 Attaches the child service policy to the VBR1 policy map. Example: Router(config-pmap-c)# service-policy child-vbr3 After you configure the policy map, you must explicitly attach it to a PVC using the service-policy command as described in the "Attaching a Service Policy to a PVC" section on page 72. Cisco IOS Release 12.0(27)S 71