Cisco ISE Software Configuration Guide - Page 67
Configuring VBR.2 Policing
UPC - 746320730097
View all Cisco ISE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Software Configuration of ATM ISE Line Cards for Cisco 12000 Series Routers How to Configure AToM VCs on the 4-Port ATM ISE Line Card Command or Action Step 10 set mpls experimental mpls-exp-value Example: Router(config-pmap-c)# set mpls experimental 4 Purpose (Optional) Specifies the value used to set the MPLS EXP bits defined by the policy map. Valid values are numbers from 0 to 7. Step 11 police rate pcr cps delay-tolerance cdvt conform-action transmit exceed-action drop Step 12 Example: Router(config-pmap-c)# police rate 500000 cps delay-tolerance 1000 conform-action transmit exceed-action drop service-policy child-vbr1 Specifies a maximum bandwidth usage by a traffic class through the use of a token bucket algorithm. For a description of the conform-action and exceed-action keywords, see Table 5 on page 16. Attaches the child service policy to the VBR1 policy map. Example: Router(config-pmap-c)# service-policy child-vbr1 After you configure the policy map, you must attach it to a PVC using the service-policy command as described in the "Attaching a Service Policy to a PVC" section on page 72. Configuring VBR.2 Policing This task describes how to configure VBR.2 policing. SUMMARY STEPS 1. enable 2. configure terminal 3. class-map match-all clp0 4. match not atm clp 5. exit 6. policy-map child-vbr1 7. class clp0 8. police rate scr cps atm-mbs mbs cells conform-action transmit exceed-action drop 9. exit 10. exit 11. policy-map vbr2 12. class class-default 13. set mpls experimental mpls-exp-value 14. policy rate pcr cps delay-tolerance cdvt conform-action transmit exceed-action drop 15. service-policy child-vbr1 Cisco IOS Release 12.0(27)S 67