Cisco ISE Software Configuration Guide - Page 93
police rate, cells conform-action
![]() |
UPC - 746320730097
View all Cisco ISE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Software Configuration of ATM ISE Line Cards for Cisco 12000 Series Routers police rate police rate To configure traffic policing, use the police rate command in policy-map class configuration mode. To remove traffic policing from the configuration, use the no form of this command. police rate pcr cps delay-tolerance cdvt conform-action action exceed-action action violate-action action police rate scr cps atm-mbs mbs cells conform-action action exceed-action action violate-action action no police rate {pcr | scr} Syntax Description pcr scr cps cells atm-mbs mbs delay-tolerance cdvt conform-action exceed-action Peak cell rate, specified for hierarchical policies. Valid values are 7 to 10,000,000,000. Sustainable cell rate, specified for single-level ATM 4.0 policies. Valid values are 7 to 10,000,000,000. Optional. Indicates that the rate value is in cells per second. If this keyword is not used, then bits per second (bps) is assumed. Indicates that the burst value is in units of cells. This option is only available if the cps keyword is used. Indicates that the ATM maximum burst size follows. Maximum burst size in numbers of cells. Valid values are 1 to 5,000,000. (Optional) Indicates that the cell delay variation tolerance follows. Cell delay variation tolerance specified as the number of microseconds. Action to take on packets that conform to the rate limit. Action to take on packets that exceed the rate limit. Cisco IOS Release 12.0(27)S 93
![](/manual_guide/products/cisco-ise-software-configuration-guide-4ef230b/93.png)