Cisco ISE Software Configuration Guide - Page 74
interface atm, l2transport, service-policy input, xconnect, encapsulation mpls
UPC - 746320730097
View all Cisco ISE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
How to Configure AToM VCs on the 4-Port ATM ISE Line Card Software Configuration of ATM ISE Line Cards for Cisco 12000 Series Routers DETAILED STEPS 6. exit 7. exit 8. interface atmslot/port 9. pvc vpi l2transport 10. service-policy input policy-map-name 11. xconnect peer-router-id vcid encapsulation mpls Command or Action Step 1 enable Step 2 Example: Router> enable configure terminal Purpose Enables privileged EXEC mode. • Enter your password if prompted. Enters global configuration mode. Step 3 Example: Router# configure terminal policy-map policy-map-name Specifies the name of the child service policy to configure. Step 4 Step 5 Example: Router(config)# policy-map atm-policy class class-map-name Example: Router(config-pmap)# class atm-class set mpls experimental mpls-exp-value Example: Router(config-pmap-c)# set mpls experimental 4 Specifies to configure the default class referred to as class-default. (Optional) Specifies the value used to set the MPLS EXP bits defined by the policy map. Valid values are numbers from 0 to 7. Step 6 exit Exits class mode. Step 7 Example: Router(config-pmap-c)# exit exit Exits policy-map mode. Step 8 Example: Router(config-pmap)# exit interface atmslot/port Specifies an ATM interface to configure. Example: Router(config)# interface atm1/0 Cisco IOS Release 12.0(27)S 74